Unofficial companion
Field Jog
Carry is the one you hold. Same face as the first deck: the wordmark, the katakana, the orange rule, the knurled knob. 214 × 300 × 22, a 6 inch ring, and a round screen in the hole that does not spin. The 88 mm shell still lines up with the Sidekick. Wide is the K.O. II size.
Loading the model
214 × 300 × 22. Brighter stone, cyan screen, orange hardware. Fader is 125 mm on the right. Caps are the 12 mm latching switches.
Renders
- Height
- 240 mm
- Width
- 88 mm
- Thick
- 16 / 22
The long edge matches the EP row, and the width matches a Sidekick. The 76 mm platter is centered, with 6 mm of deck on each side. The knob sits above it. It is 16 mm thick where it meets the row, the same as a K.O. II and a Sidekick. The top 52 mm rises to 22 mm so a 2×AA holder fits. That rise is part of the top shell. The two halves close on four pairs of magnets. The deck is not engraved. Type tore out of the first print, so the lettering is vinyl, cut 1:1 for a Cricut. The raised end carries the name, the port row and the tempo label. The buttons are labeled on the deck. The platter encoder is a MagnTek MT6701 on a 26 mm pad. Four M2 holes, 17.5 mm apart. Pin holes are 16, 25, 48, 216 and 224 mm from the fader end, 8 mm off the bottom, on both long sides.
Wide shells
176 × 240.5 × 16.3 mm. Twin is two 76 mm platters. Six is one 152 mm platter, set left so the pitch fader has a lane beside it. Print the top face up and the tray cavity up. IN, OUT and the other toggles are a 12×12×7.3 mm switch. Its own cap comes through the hole. CUE and PLAY stay printed plungers. Each platter sits over a MagnTek MT6701. The pad is 26 mm square, four M2 holes on a 17.5 mm square. Solder VDD, GND, SCL and SDA. Leave Analog/PWM open, and do not fit a pin header. The rear jacks sit between the magnet posts. On Twin the headphone jack is left of the crossfader. On Six it is centered. The microSD mouth is on the underside, 36.5 mm from the left and 27 mm in from the jack end.
Wide
Vinyl
Cut this in black vinyl. The screen, the knob and the platter stay clear. On the mat file the left piece is the deck and the right piece is the faceplate. A 10 mm bar sits in the gap. If the import comes in small, scale it until that bar is 10 mm.
Parts
Also in the zip
OpenSCAD source, a Pro Micro MIDI sketch, and the print notes. Face-up, no supports, 0.2 mm layers.
ECM sleeve
A 96 × 18.8 mm handheld shell for an ECM-77B head. The capsule slides in from the tip and the cable leaves the back. The orange button is a cap.